Gecko [ contributie.vriendennsm.nl ]

Name	Size	Permission	Date
10-console-messages.conf	77 B	-rw-r--r--	2016-01-13 11:48
10-ipv6-privacy.conf	490 B	-rw-r--r--	2016-01-13 11:48
10-kernel-hardening.conf	726 B	-rw-r--r--	2016-01-13 11:48
10-link-restrictions.conf	257 B	-rw-r--r--	2016-01-13 11:48
10-magic-sysrq.conf	1.16 KB	-rw-r--r--	2016-01-13 11:48
10-network-security.conf	509 B	-rw-r--r--	2016-01-13 11:48
10-ptrace.conf	1.26 KB	-rw-r--r--	2016-01-13 11:48
10-zeropage.conf	506 B	-rw-r--r--	2016-01-13 11:48
99-sysctl.conf	2.19 KB	-rw-r--r--	2026-02-25 16:31
README	519 B	-rw-r--r--	2016-01-13 11:48

Rename

#
# /etc/sysctl.conf - Configuration file for setting system variables
# See /etc/sysctl.d/ for additional system variables.
# See sysctl.conf (5) for information.
#

#kernel.domainname = example.com

# Uncomment the following to stop low-level messages on console
#kernel.printk = 3 4 1 3

##############################################################3
# Functions previously found in netbase
#

# Uncomment the next two lines to enable Spoof protection (reverse-path filter)
# Turn on Source Address Verification in all interfaces to
# prevent some spoofing attacks
#net.ipv4.conf.default.rp_filter=1
#net.ipv4.conf.all.rp_filter=1

# Uncomment the next line to enable TCP/IP SYN cookies
# See http://lwn.net/Articles/277146/
# Note: This may impact IPv6 TCP sessions too
#net.ipv4.tcp_syncookies=1

# Uncomment the next line to enable packet forwarding for IPv4
#net.ipv4.ip_forward=1

# Uncomment the next line to enable packet forwarding for IPv6
#  Enabling this option disables Stateless Address Autoconfiguration
#  based on Router Advertisements for this host
#net.ipv6.conf.all.forwarding=1

###################################################################
# Additional settings - these settings can improve the network
# security of the host and prevent against some network attacks
# including spoofing attacks and man in the middle attacks through
# redirection. Some network environments, however, require that these
# settings are disabled so review and enable them as needed.
#
# Do not accept ICMP redirects (prevent MITM attacks)
#net.ipv4.conf.all.accept_redirects = 0
#net.ipv6.conf.all.accept_redirects = 0
# _or_
# Accept ICMP redirects only for gateways listed in our default
# gateway list (enabled by default)
# net.ipv4.conf.all.secure_redirects = 1
#
# Do not send ICMP redirects (we are not a router)
#net.ipv4.conf.all.send_redirects = 0
#
# Do not accept IP source route packets (we are not a router)
#net.ipv4.conf.all.accept_source_route = 0
#net.ipv6.conf.all.accept_source_route = 0
#
# Log Martian Packets
#net.ipv4.conf.all.log_martians = 1
#

# Promote secondary addresses when the primary address is removed
net.ipv4.conf.default.promote_secondaries = 1
net.ipv4.conf.all.promote_secondaries = 1